Rednet 5

Pro Tools HD Bridge

Scarlett 2i4 Header

Articles

Pro Tools Setup: On the Pro Tools Hardware Setup page (click Setup > Hardware), select each RedNet 5 unit in turn and click the Set to Default button. This will ensure that the RedNet 5 is...
The No More Flows error in Dante Controller is commonly caused by people using Static IP Addresses and trying to route between Dante Virtual Soundcard and RedNet devices. It can also happen if you...
RedNet Control can do block routing based on the amount of Input/Output channels of a given device. This is great for quick routing, which is fine in most situations. But sometimes you may wish to...
If you find that you have no metering on the graphics in RedNet Control, then this is likely due to a FireWall on your system. You will need to add RedNet Control to the list of exceptions for your...
Currently, in order for Dante Virtual Soundcard to pass audio correctly a certain Dante Latency setting must be used in the Dante Virtual Soundcard settings. You must switch off Dante Virtual...
Dante makes use of standard Voice over IP (VoIP) protocols and utilises Quality of Service (QoS) switch features, to prioritize clock sync and audio traffic over other network traffic. VoIP QoS...
A RedNet 5 will allow up to 32 channels of inputs and 32 channels of outputs between your Pro Tools rig and RedNet network (16i/o at 192kHz sample rates), via standard DigiLink connections. RedNet 5...
A RedNet PCIe card is not essential, as RedNet 5 uses Pro Tools HD cards to get low latency audio in and out of Pro Tools and RedNet. RedNet 5 acts as the host in this case.
A RedNet PCIe card is not necessary, as RedNet 5 uses Pro Tools HD cards to get low latency audio in and out of Pro Tools and RedNet. RedNet 5 acts as the host in this case. You could of course route...